Main Menu - Grundfos Conex DIA-2Q Bedienungsanleitung

Setup
"F" (full rights)
• Selecting language
• Parameter 1/2: selecting measured values
• Selecting measuring cell
• Selecting measuring range
• Configuration of controller 1/2
• Switching on/off water sensor
• Time setting
• Code function
• Display contrast
• Calling up factory settings
• Current output: assignment of current outputs to
measuring ranges
• Calling up program version.
Calibration function
"C" (calibration rights)
• Calibration of selected parameters
– chlorine, chlorine dioxide, ozone, peroxide,
peracetic acid, pH.
Manual operation
"C" (calibration rights)
• Running the configured controllers manually.

11.4 Main menu

1. Switch to "main menu" by pressing [OK] or, if
necessary, by pressing [Esc] several times.
Options in "main menu"
main menu
controller
alarm
service
setup
• "controller"
In this submenu, a controller can be
parameterised. This option will only be displayed
if a type of controller has been selected in the
"setup" menu.
• "alarm"
In this submenu, the measured value is
compared with the permitted value, and an alarm
is triggered, if necessary.
• "service"
Diagnosis submenu. The measured values and
the last 10 alterations of calibration data can be
viewed. In this mode, values cannot be altered.
If measuring cell AQC-D2/-D12 is selected, the
data of the water sensor can be viewed.
• "setup"
In this submenu, the settings for language,
parameters, measuring ranges, controllers, etc.
can be adjusted.
Selecting the functions "calibration" and
"manual operation"
See the buttons [Cal] and [Man] to the right of the
display.
• Calibration: Press [Cal] to switch to the
calibration menu (the yellow LED illuminates).
• Manual operation: Press [Man] to switch to
manual operation (the yellow LED illuminates).
Switching to manual operation is only
possible if a controller type has been
selected in the "setup" menu. The
Note
functions "Cal" and "Man" can only be
accessed by persons with calibration rights
or full rights.
29