Herunterladen Inhalt Inhalt Diese Seite drucken

Changing The Battery - Schaudt EBL 226 C +OVP Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Instruction Manual Electrobloc EBL 226 C +OVP
Step switch
Operation with solar
regulator

Changing the battery

4
Refrigerator control
F
Wastewater tank heating
F
Awning light
F
For further information, see the instruction manual of the DT/LT ... control
and switch panel .
The supply to the step is protected by a self-resetting fuse. This is why the
step switch may only be activated briefly.
ATTENTION!
Y
Activating the step switch too long results in too high a current!
Self-resetting fuse can activate:
Only press the step switch briefly.
F
If the self-resetting fuse has triggered, it needs about one minute to reset
before the step switch can be pressed again.
ATTENTION!
Y
No battery buffer function!
Damage to connected devices:
Do not operate solar regulator without battery connected.
F
3.2
Changing the battery
ATTENTION!
Y
Use of incorrect battery types or incorrectly rated batteries.
Damage to the battery or devices connected to the electronic block:
Batteries should only be changed by qualified personnel.
F
Follow the instructions of the battery manufacturer.
F
Only connect the electronic block to 12 V power supplies with rechar-
F
geable 6-cell lead gel or lead acid batteries. Do not use any uninten-
ded battery types.
Only batteries of the same type and capacity as those installed by the
Y
manufacturer should normally be used.
It is possible to swap lead acid batteries with lead gel batteries. Changing
Y
from lead gel batteries to lead acid batteries is not possible without over-
head. Contact the vehicle manufacturer for more information.
Electrically disconnect the battery from the Electrobloc. To do this, enable
the battery isolation on the DT/LT ... control and switch panel (see also
section 3.4).
Remove "+ solar cell" connector on the solar charge regulator.
Isolate Electrobloc from the mains voltage (230V AC).
Replace battery.
After changing the battery, recheck which type of battery has been inser-
ted.
Date: 30.09.2009
811.573 BA / EN

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis