Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.2 Teaching-in
Please read this entire section before starting the
teach-in procedure.
• To execute the teach-in procedure, both of the
devices to be connected must be in teach-in mode
and the channel to be taught-in must be selected.
• To teach-in to a particular actuator channel, hold
the corresponding channel button (K1–K4) down
for approximately four seconds. If the channel LED
flashes continuously, this signals that teach-in mode
is active.
• If no teach-in operations are carried out, teach-in
mode will be exited automatically after 20 seconds.
If other devices are also in teach-in mode, they will
be taught-in.
8
Operation
After teach-in has been performed, simple operator
functions are available via the taught-in control
elements. Depending on the taught-in control element,
the switch actuator can be controlled by means of an
ON/OFF pair of buttons or by toggling.
25
Werbung
Kapitel
Inhaltsverzeichnis
