Teaching-In On Max! Components - eQ-3 MAX! Eco Bedienungsanleitung

A
• If you are working with a stone wall, drill the marked two
5 mm holes and insert the plugs supplied. If you are wor-
king with a wooden wall, you can pre-drill 1.5 mm holes
to make screws easier to insert.
• Use the screws and plugs supplied to fasten the moun-
ting plate to the wall.
• Attach the electronic unit with the
frame on the mounting plate. Make
sure that the arrows on the back side
of the electronic unit point upwards
and that the clips on the mounting
plate latch into the openings on the
electronic unit.

7. Teaching-in on MAX! Components

The MAX! Eco switch communicates centrally via the MAX!
Cube with the MAX! components. In order to teach in the
MAX! Eco switch on the MAX! system, proceed as follows:
• Start the local software and click on „New device".
B
B
A
19