Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9
Resetting to the initial state
To reset the actuator to the initial state, do the
following:
• Put the device into teach-in mode using the (K1)
channel button (hold it down for at least 4 seconds).
• If the device is in teach-in mode, hold the (K1)
channel button down for at least 4 seconds again.
• If the device LED flashes quickly, this indicates that
the actuator is being reset.
10 Channel LED feedback
10.1 Flashing codes
Various actuator states are indicated by the
channel LED(s) flashing:
Flashing sequence
Slow flashing
Fast flashing
One long flash, n brief
flashes (depending on
the type of error)
26
State
Teach-in mode
Reset
Error
Werbung
Kapitel
Inhaltsverzeichnis
