Christopeit Sport RS 3 Montageanleitung Seite 23

Step 6:
Installation of the pulse grip (3) at the seat frame (2).
1. Place the pulse grip (3) from bottom side to the holder at seat frame
(2) and adjust the holes in the tubes so that they are aligned. Push the
bolts M8x45 (10) from bottom side through the holes and tighten the
pulse grip (3) at seat frame (9) with washers 8//16 (15) and cap nuts (11)
firmly.
2. Connect the plugs of pulse connection cables 2 (42) and pulse cables
(41).
Step 7:
Attach the seat (36) and back cushion (37) at seat support (2).
1. Place the seat (36) with back side onto the seat support (2) sothat the
holes are align.
2. Put on each screw M8x16 (14) one washer 8//16 (15) and tighten the
seat (36) at seat support (2) firmly.
3. Place the back side of back cushion (37) against den seat holder (2) so
that the holes align.
4. Screw the back cushion (37) at seat holder (2) tightly by using screws
(14) and washers (15).
Step 8:
Attach the power with adaptor (29).
1. Please insert the cable plug of adaptor (29) into the DC cable plug (89)
at end of chain guard (55).
2. Please insert the adaptor (29) into a well installed socket with wall power
(230V~50Hz).
Step 9:
Checks
1. Check the correct installation and function of all screwed and plug
connections. Installation is thereby complete.
2. When everything is in order, familiarise yourself with the machine at a
low resistance setting and make your individual adjustments.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later.
23