Christopeit Sport RS 3 Montageanleitung Seite 21

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts are connected directly to the main
frame preassembled. In addition, there are several other individual parts
that have been attached to separate units. This will makes assembly
easier and quicker for you. Assembly time: 40 - 50 min.
Step 1:
Attach the stabilizer (6+7) at main frame (1).
1. Attach the front foot (6) with the preassembled end caps with transport
rollers (25) to the main frame (1). Do this with the two screws M8x75
(9), curved washers 8//20 (12), spring washers (13) and cap nuts (11).
2. Attach the rear foot (7) with preassembled end caps with height
adjustment (26) to the main frame (1). Do this with the two screws (9),
curved washers (12), spring washers (13) and cap nuts (11).
3. Attach the transportation grip (49) at rear foot (7) with screws M8x75
(50) Curved washers (12) and spring washers (13)
4. Screw in the rubber foot (28) into the appropriate threat of main frame (1)
and secure position with nut (23). After assembly has been completed,
you can compensate for minor irregularities in the floor by turning the
wheel at end cap (26) and rubber foot (28). The equipment should be
set up that the equipment does not move of its own accord during a
training session. If you like to change the position of the recumbent
bike, lift up at transportation grip (49) until you can move easy on the
front transportation rollers to another place.
Step 2:
Attach the pedal (27L+27R) at pedal crank (40L+40R).
1. Screw the right pedal (27R) into the locator in the right-hand side (as seen
in operation) for the pedal crank (40R) (Warning! the screw direction is
clockwise).
2. Screw the left pedal (27L) into the locator in the left-hand side (as seen
in operation) for the pedal crank (40L) (Warning! the screw direction is
anti-clockwise).
3. Then mount the pedal straps left and right on the
associated pedals (27). (The pedals are signed with "L"
for Left and "R" for Right.)
Schritt 3:
Attach the computer holder (5) at main frame (1).
1. Place the computer holder (5) against the main frame (1) and connect
the plug for the computer cable (30) with the matching plug for the motor
cable (42). Connect the plugs of pulse connection cables 3 (45) with the
matching plug of pulse connection cables 2 (42) too.
2. Place the computer holder (5) onto the locator provided for it at the main
frame (1). Ensure that the cable connections made are not squashed.
Screw the computer holder (5) onto the main frame (1) in straight
direction with screws M8x16 (14), spring washers (13) and curved
washers 8//20 (12).
21