General Notes - Scheppach Ox 3-1200 Originalanleitung

scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Germany
We hope you have a lot of fun and success using your
new machine.
Note:
Under current product liability regulations, the manufac-
turer of this equipment will not be liable for damages to
the equipment or caused by it in the case of:
• improper handling,
• failure to observe the operating instructions,
• repairs by third parties, non-authorised technicians,
• installation of and replacement by non-original spare
parts,
• non-intended use,
• failures of the electrical system while not adhering
to the electrical regulations and regulations of the
VDE (German Association for Electrical, Electronic
and Information Technologies) 0100, DIN 57113 /
VDE0113.
Our recommendations:
Read the entire text of the operating instructions before
installation and operation.
These operating instructions are to help you to get to
know your machine and its intended fields of application.
The operating instructions contain important notes on how
to work safely, properly, and efficiently with the machine
and how to avoid hazards, save costs of repairs, keep
downtimes short und improve reliability and product life
of the machine.
In addition to the safety instructions in this manual, you
must observe all regulations of your country applicable
for the operation of the machine.
Keep the operating instructions close to the machine,
protected by a plastic envelope against dirt and humidity.
Any operator must read the operating instructions prior
to work and follow them precisely. Only people trained to
operate the machine and who are aware of the associated
dangers are permitted to work with the machine. The
required minimum age must be observed.
• After unpacking, inspect all parts for possible transport
damages. In the case of complaints you must inform
the deliverer immediately. Subsequent complaints will
not be accepted.
• Check the shipment to ensure that it is complete.
• Familiarise yourself with the equipment with the help
of the operating instructions before putting the equip-
ment into operation.
• Use only original parts as accessories and spare parts.
You can buy spare parts from your specialist dealer.
• When you order, please state our order numbers as
well as the equipment's type and year of manufacture.
Downloaded from www.Manualslib.com
Manufacturer
Dear customer

General Notes

manuals search engine
Ox 3–1200
Scope of Delivery
hydraulic log splitter
operating instructions
Specifications
830 x 540 x 1560
Dimensions D/W/H
50/430/810
Table height mm
working height mm
600/965/1040/1330
log length max cm
power max. t*
cylinder travel cm
forward speed cm/s
return speed cm/s
oil volume l
weight kg
Noise level at idle
dB(A)
Drive
400 V/50 Hz
Motor
input power P1 kW
output power P2 kW
S6/40 %
duty type
motor speed 1/min
motor protection
phase inverter
Specifications are subject to change!
* The maximum achievable splitting power depends on the resist-
ance of the material to be split and can, due to influencing vari-
able, deflect to the hydraulic system.
Warning Symbols / Warnings
Please read the manual before start-up
Wear safety footwear
Wear work gloves
Use hearing protection and safety goggles
Wear a hardhat
Authorised personnel only
No smoking in the working area
Do not spill hydraulic oil on the floor
Keep your workspace clean! Untidiness can
cause accidents!
If a crane is used, put the lifting belt round
the housing. Never lift the firewood splitter by
the hand grip,
Dispose of waste oil correctly (waste oil coll-
ection point on site). Do not dump waste oil
in the ground or mix it with waste.
Do not remove or modify protection and
safety devices.
930
12
53
4
20
9,0
199
88
4,10
3,30
1420
yes
yes
english 9