Limited Warranty - Ossur CTi CUSTOM Bedienungsanleitung

Downloaded from www.Manualslib.com
of the hook-and-loop fastener to which the silicone liner was originally
fastened (Figure 11). Press the silicone liner back into place on top of the
wedge pad. Fine tune the padding until your CTi brace fits snugly against
the tibia (Figure 12).
CHANGING EXTENSION STOPS
Extension stops are available for varying degrees of extension control.
1. Remove the pad from the condylar area.
2. Using a short Philips head screwdriver, remove the screw in the
center of the hinge plate (Figure 13).
3. Locate the extension stop positioned in the hinge between the upper
and lower arms of the brace. With brace slightly bent, push the
extension stop from the back of the brace through to the front. This
should cause the stop to pop out of the hinge (Figure 14).
4. From the bag of extension stops included with the brace, choose the
stop which corresponds to the desired degree of extension. Feed the
hole end of the stop through the hinge from the front to the back of
the brace, with the curved side facing down and the flat edge facing
up. Make sure that the sharp extrusions on the flat end of the
extension stop are pointed toward the distal portion (bottom half) of
the brace (Figure 14). The flat end of the stop should be visible from
the front of the brace.
5. Align the hole in the center of the hinge plate with the hole in the
extension stop. Replace and tighten the screw through the hinge plate
and extension stop. Replace the pad. This procedure must be
completed on both the medial and lateral hinges.
6. Choose the appropriate extension stop (Blue = 0°, Black = 0–10°, Dark
Gray = 10–20°, Medium Gray = 20–30°, Light Gray = 30–40°)*
* These numbers are approximate. Actual extension stop will vary
from person to person depending on anatomical differences.
Appropriate extension stop size is normally determined by health
care provider.

LIMITED WARRANTY

This warranty covers all defects in materials and workmanship of your
new CTi Knee Brace. This Warranty covers the rigid carbon fiber brace
frame and Accutrac™ hinges for the lifetime of the patient that the brace
was originally built for. The warranty covers all other materials, including
straps, sleeves, liners and pads for six months from the date of
original purchase.
Össur will repair or replace (at its option) any defective part covered
under warranty at no charge. Repairs necessitated by accident,
negligence, misuse or abuse by the purchaser are not covered. Also,
consequential and incidental damages are not recoverable under this
warranty. These limitations may not apply as some states do not allow
the exclusion or limitation of incidental or consequential damages. Only
the original purchaser is entitled to claim service under this warranty.
With the brace you get a one year fit guarantee.
To obtain service under this warranty call our Customer Service
Department.
8
manuals search engine