Tools Required - Horizon Fitness COMFORT 2.0 Benutzerhandbuch

TOOLS REQUIRED:

F 13/15mm Flat Wrench/Screwdriver
F 6mm L-Wrench
PARTS INCLUDED:
F 1 Main Frame
F 1 Console
F 1 Console Mast
F 1 Console Mast Grommet
F 1 Water Bottle Holder
F 1 Front Stabilizer
F 1 Rear Stabilizer
F 1 Seat
F 1 Seat Post Tube
F 2 Pedals with Straps
F 1 Audio Adapter Cable
F 1 Power Cord
F 1 Hardware Kit
UPRIGHT BIKE PRE ASSEMBLY
UNPACKING
Unpack the product where you will be using it. Place the bike carton on a level
flat surface. It is recommended that you place a protective covering on your
floor. Never open box when it is on its side.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded. It is recommended you complete the full assembly of your
unit before completely tightening any ONE bolt.
Several parts have been pre-lubricated to aid in assembly and usage. Please
do not wipe this off. If you have difficulty, a light application of lithium bike
grease is recommended.
NEED HELP?
If you have questions or if there are any missing parts, contact your local
dealer. Contact information may be located on the back panel of your
manual or on the warranty card.
Comfort
Upright
Bike
17