Replacing The Power Cable; Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-US 350 Originalbetriebsanleitung

certain position.
•
If necessary, you can use the adjustment
knob (23) to adjust the lateral displacement.
•
Important! While you are adjusting the lateral
displacement using the adjustment knob (23),
turn the grinding/sanding belt (6) by hand at
the same time or in between.
•
To move the grinding/sanding belt to the right,
turn the adjustment knob (23) counterclock-
wise (see Fig. 16).
•
To move the grinding/sanding belt to the left,
turn the adjustment knob (23) clockwise (see
Fig. 17).

6. Operation

6.1 ON/OFF switch (1)
To switch on the equipment set the On/Off switch
(1) to position I.
Move the ON/OFF switch (1) to position 0 to
switch off the equipment.
After switching on the equipment wait for the
equipment to reach its maximum speed of rotati-
on before commencing with the sanding/grinding
work.
6.2 Grinding/sanding
•
Place the workpiece onto the workpiece
support (7) and slowly guide the workpiece
towards the grinding/sanding wheel (5) at the
desired angle to the point where workpiece
and grinding/sanding wheel make contact.
•
Move the workpiece slightly back and forth to
produce an optimal grinding/sanding result.
This way the grinding/sanding wheel (5) will
be evenly worn. Allow the workpiece to cool
down occasionally.
6.3 Grinding/sanding with the belt
•
Always hold the workpiece firmly during grin-
ding/sanding.
•
Do not exert excessive pressure.
•
The workpiece should be moved to and fro
on the belt as you grind/sand it to prevent the
paper wearing on one side.
•
Important! Pieces of wood should always be
sanded with the grain to prevent them split-
ting.
Caution!
If the grinding/sanding wheel or the grinding/san-
ding belt becomes jammed during operation, re-
Anl_TC-US_350_SPK9.indb 25 Anl_TC-US_350_SPK9.indb 25
GB
move the workpiece and wait until the equipment
reaches its top speed again. You may have to
guide the workpiece towards the grinding/sanding
wheel or grinding/sanding belt with less force.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 25 -
25.06.2020 12:20:50 25.06.2020 12:20:50