Continuous Operation; Replacing The Power Cable - EINHELL TC-DWS 225 Originalbetriebsanleitung

5.1.2 Connecting the dust extractor hose
(Fig. 4 / Item 12)
1. Push the dust extractor hose (12) onto the
dust extractor connection (a) as shown in Fig.
4 and lock it by twisting clockwise.
2. Extraction takes place directly through the
abrasive paper and the grinding/sanding disk
(8) into the dust bag (11).
5.1.3 Emptying and cleaning the dust bag
(Figs. 5/6 / Item 11)
To empty the dust bag (11), pull the clips (c) off
the emptying opening (Fig. 5). You can now empty
and clean the dust bag (11) via the generously
sized opening (Fig. 6). When fi nished with the em-
ptying and cleaning you must push the clips (c)
back into place on the emptying opening (Fig. 5).
Then the dust bag can be used again. No more
steps are required.
Caution:
For health safety reasons it is imperative that you
use a dust extractor.
5.2 Attaching the abrasive paper (Fig. 7)
The hook-and-loop fastener enables easy chan-
ging of the abrasive paper. Make sure that the
vacuum extraction holes on the abrasive paper
and the sanding disk are aligned.
5.3 Adjusting the additional handle (Fig. 8 /
item 4)
You can turn the additional handle (4) into the
most comfortable position for you.
•
Undo the two fastening screws for the additio-
nal handle (5).
•
Adjust the additional handle (4).
•
Re-tighten the two fastening screws for the
additional handle (5).
6. Operation
6.1 On/Off switch (Fig. 9 / item 1)
Switching on:
Press the On/Off switch (1).

Continuous operation:

Lock the On/Off switch (1) in place by pressing
the locking button (2).
Anl_TC_DWS_225_SPK13.indb 15 Anl_TC_DWS_225_SPK13.indb 15
GB
Switching off :
Press the On/Off switch (1) briefl y and then re-
lease it.
6.2 Speed controller (Fig. 9/ item 3)
You can select the speed by turning the speed
controller (3).
Plus direction: Higher speed
Minus direction: Lower speed
6.3 Working close to edges
(Fig. 10-11 / item 6)
To work close to edges and remove the side part
(6) as shown in Fig. 10.
Now you can run the tool straight along the edge
of a wall. (See Fig. 11)
6.4 Working with the drywall power sander
•
Place the whole surface area of the sanding
head on the material.
•
Switch on the machine and move it with
gentle pressure over the „workpiece", making
circular or transverse and linear movements.
•
Use a coarse grit for coarse sanding and a
finer grit for finish sanding. You can find the
best grit size for the job by carrying out san-
ding tests.
Caution!
The dusts which are formed while the equipment
is being used may be a health hazard:
•
Always wear safety goggles and a dust mask
during sanding work.
•
All persons who work with the equipment or
enter the workplace must wear a protective
dust mask.
•
Eating, drinking and smoking are prohibited
at the workplace.
•
Paints containing lead are not allowed to be
used!

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
- 15 -
20.04.2023 15:22:01 20.04.2023 15:22:01