Start Charge-Discharge Process; Display During A Charge Process; Display During Charge/Discharge And Cycling Process - Multiplex Power Peak Twin EQ-BID 1000W Bedienungsanleitung

6.1

START CHARGE-DISCHARGE PROCESS

Before starting the programmed procedure, the battery must be connected with the correct
polarity to output 1 or 2. Use the appropriate charge lead, for example, from the compre-
hensive Multiplex range.
Note: Lithium batteries should a Note: Lithium batteries should always be charged with the Voltage Sensor lead connected.
7.

DISPLAY DURING A CHARGE PROCESS

7.1

DISPLAY DURING CHARGE/DISCHARGE AND CYCLING PROCESS

Following the start, the screen changes to the working display, which shows all the impor-
tant values of the running procedure. The illustration shows the working display for a nor-
P Pressing the "MODE" button, changes to the 2nd and 3rd screens, where these values i th "MODE" b tt
can be read. Pressing the "ESC" button will return to previous screen. The displayed
value for the internal resistance will be automatically calculared by the Power Peak ® Twin
EQ-BID.
Note: Note:
During a charge-discharge process, pressing the "ENTER" button, the current can be
changed using the "DEC" or "INC" buttons. This change applies only for the running pro-
cess and will not be stored.
Operating Instructions
Power Peak ® Twin EQ-BID
Pressing the "ENTER" button for at least 2 seconds starts
the charger operation. A warning signal sounds and the
charger checks that a battery is connected and shows this
in the display screen. The illustration here shows this pro-
cedure. If a battery is not connected, the display will show
an error messadge and an alarm will sound.
mal charge process in "Normal" (L-NORMAL) mode. The
working display is divided into 3 sections.
h h 2 d
The discharge process runs in a similar manner.
"DISCHARGE" is shown when checking the battery. The
illustration shows the first screen during a discharge pro-
cess in "Normal" (E-NORMAL) mode.
21
55
d 3 d
# 30 8563