"Mode" -Button; Using The Charger For The First Time - Multiplex Power Peak Twin EQ-BID 1000W Bedienungsanleitung

"MODE" -BUTTON

This button navigates through the main menus in the following sequence:
play of the BID-Chip/Key data, when a BID-Chip/Key (BID-SYSTEM) is connected.
VIEW)
"ESC" BUTTON
"CH"-BUTTON
during a charge process.
5.

USING THE CHARGER FOR THE FIRST TIME

Observing correct polarity, connect the Power Peak ® Twin EQ-BID using the gold banana
connected to one output compared to the other. E.g., dividing 80% to output 1 and 20% to
output 2 allows a higher charge current to be set for output 1.
Once the correct parameters have been entered press the 'ESC' button to continue to the
main screens for outputs 1 or 2.
Operating Instructions
Power Peak ® Twin EQ-BID
connectors (use the crocodile clips for a car battery) to a
suitable 11-28 V DC power supply. The Home display will
now appear. The User Name and software version in ope-
ration will be shown next to the Multiplex logo and the device
name. A short device self-test will also be made.
After this, the Input Power Display will appear. This allows
you to set the maximum voltage available from the power
source and to adjust the charger to the maximum perfor-
mance without overloading the source. Additionally, the
power can be set as a percentage for each of the charger
outputs (channels). This is useful when, for example, a
battery power pack with a higher cell count and capacity is
8
42
# 30 8563
-