Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Programming cup
EN
capacity
Factory setting
Setting range
Button
[ml]
45
30 – 100
105
80 – 200
200
100 – 240
65
65 – 130
Before programming, always
insert a new capsule into the
machine.
The newly programmed fill
quantity remains stored (also
if power is interrupted).
It is also possible to reset the fill
quantities of the cups to the factory
settings. To do this, read the fre-
quently asked questions on page 26.
12
1
[ml]
The appliance is ready for
operation. Place desired cup
under the spout.
4
Hold down the button for
the desired beverage (e.g.
"lungo") for at least 3 sec.
5
Open lever, capsule falls into
container.
2
Open lever and insert desired
capsule.
3 sec. min.
The respective symbol will
start flashing on the display.
Then release the button - the
machine continues brewing.
3
Close lever completely.
Press the same button again
as soon as the desired cup
filling quantity has been
reached. The machine stops
the brewing process and saves
the new cup filling quantity.
Werbung
Inhaltsverzeichnis
