Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Start-up of the appliance
EN
Please read the safety instructions
before starting up the appliance.
If you decide to insert the
water filter, do not screw the
filter into the water tank until after
starting up the machine; proceed to
rinse the machine again with at least
200 ml of water. Activate the "Fil-
ter available" setting. Refer to the
"Parameter setting - water filter"
instructions (see page 22).
If the machine has been ex-
posed to temperatures below
freezing, please do not switch the
machine on for at least 3 hours so
that it can come back to room tem-
perature. It is possible that a frozen
or very cold machine will not func-
tion properly.
Before using the machine for
the first time, run 4 rinsing
cycles. To do that, press the rinse
button once the previous rinsing
process has been completed.
Risk of scalding!
Very hot water.
10
1
Firstly check the voltage on
the type plate (see underside
of machine).
4
Re-insert water tank.
7
Press the rinse button to start
rinsing process.
2
Remove water tank and rinse
it thoroughly with a smooth
cleaning agent.
5
On
Briefly press the on/o but-
ton. Machine is heating up.
8
8
Wait until rinsing process
has finished. Then empty the
container.
3
max
3.5 l
Fill water tank with fresh
potable water
6
Close lever completely.
Use a container.
11
9
The appliance is ready for
operation.
Werbung
Inhaltsverzeichnis
