Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mounting and Connection Instructions Sounder/Flasher with 2 Inputs BUS-2
9.
Mounting Tear-off contact
Screw the spacer and the PCB with the tear-off contact to the mounting surface
Distance between the switch and the bottom plate approx. 2 mm or approx. 15 mm between the PCP
top and the bottom plate.
Place washer(s) underneath
10.
Final assembly
The device is designed for wall mounting.
Mounting in compliance with VdS:
Strain relief of cables:
Before closing the housing, secure the cable binders at the provided retainers.
Seal housing:
Seal the housing after mounting correctly and testing the system by pressing the plastic seal into the
screw opening o nthe housing.
Clean the seal (free from grease) and cover with the label (VdS imprint).
After attaching the plastic seal, the housing cannot be opened without destroying the seal.
to adjust positioning if necessary.
Sideview
Washer above
Washer below for
adjustment
Bottom plate
Mounting surface
15 mm
2 mm
15
as shown.
height
Werbung
Kapitel
Inhaltsverzeichnis
