Final Assembly - ATH-Heinl Single Lift 35M Bedienungsanleitung

Final assembly

Fit the front cover using the supplied
spring, spring bolt and bracket as shown in the adjacent diagram.
Install the remaining rear covers on the column using the supplied
M6x10 screws.
General final checks
Check all fixing screws and bolts.
Check that the chain has been correctly installed.
Make sure that the electrical installation has been carried out correctly.
Check the rotational direction of the motor.
Carefully inspect the operation of the safety catch, support arm lock and all other safety equipment.
Ensure that all end switches switch to the correct position safely and reliably.
Hydraulic system checks
Check the oil level and refill as required.
Raise lift completely and press for 5 seconds (bridge limit switch at top).
Check that all hose connections, the unit and the cylinder are leak-tight.
Vent the cylinder again, if required.
Tests under load
Place a vehicle on the lift and operate 3 complete lifting and lowering
procedures. Carefully observe the lift and the load while doing so.
Pay attention to whether there are any unusual or loud noises when lifting or lowering.
To finish, fully lubricate the lift again at the required points.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Manufacturer ATH-Heinl GmbH & CO.KG
- 23 -