ATH-Heinl Single Lift 35M Bedienungsanleitung Seite 67

Base frame / column feet assembly
Place the column in a vertical position. Ensure the column is
standing securely and cannot be knocked over.
Place the two column feet at the side of the column. Check
whether both rollers are already installed in the feet.
Connect the two arms using the supplied M20X50 screws and
take care to follow the correct order of washers and spring
washers as shown in the adjacent diagram.
Hydraulic unit assembly
Attach the hydraulic unit to the bracket on the rear of the column as
shown in the adjacent diagram. Use the supplied M10X50 screws
and corresponding washers for this purpose.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Manufacturer ATH-Heinl GmbH & CO.KG
- 17 -