ATH-Heinl Single Lift 35M Bedienungsanleitung Seite 70

Assembling the arm together with the support
plates
Fit the arm on the lifting carriage of the
lift. Use the two M16X70 screws (1), four M16X60 screws
(2) and the
corresponding washers supplied for this purpose as shown
in the adjacent
diagram.
Install all the support arm components on the arm as shown in the adjacent diagram. Ensure that all
components are assembled and the safety equipment works reliably.
No. Description
1 Rear support arm
Left rear support arm
2
extension
Left rear support arm
3
holding fixture
4 Arm base plate
Right rear support arm
5
holding fixture
6 D.12 washer
7 M12X30 screw
8 4X16 bolt
9 M8X60 screw
10 Support arm release
11 Spring
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
No. Description
12 M8X12 screw
13 Mounting plate
Right rear support arm
14
extension
15 Support plate
Support plate holding
16
fixture
17 Bolt
18 Notched plate
19 Support arm release
20 Flat-head bushing
21 Guard bracket
22 D.6 washer
Manufacturer ATH-Heinl GmbH & CO.KG
- 20 -
2
No. Description
23 M6X8 screw
24 Front right extension
25 D.25 circlip
26 M6X12 screw
27 M10X20 screw
28 D.10 washer
29 Plastic sliding part
30 Variable arm extension
31 Front left extension
1