ATH-Heinl Single Lift 35M Bedienungsanleitung Seite 55

1. Lifting column
The lifting carriage is guided by rollers as it moves up and down the lifting column.
The hydraulic lifting cylinder and the lifting chain are also located here.
2. Lifting carriage
The lifting carriage supports the arm (load bearing equipment). It is lifted and lowered by the
hydraulic cylinder by means of chains; it is guided in the column by rollers.
3. Arm
The adjustable support arm and support plate are attached here. The length of the arm
can be adjusted.
4. Drive kit
Serves to drive and position the lift. The procedure may only be carried out when empty without a
load.
5. Control box
The complete electrical control system is located here. All buttons are protected by a front ring in
order to prevent them being pressed accidentally. Furthermore, all movements are immediately
stopped when the buttons are released (dead man's control).
6. Hydraulic unit
The hydraulic oil is fed from the tank to the lifting cylinder by a gear pump driven by an electric
motor. The lowering valve allows the oil to flow back into the tank.
7. Base frame
Serves to stabilise the lift and contains the front rollers which drive the lift.
8. Release magnet
Electromagnet for releasing the safety catch during the lowering process.
The safety catch prevents the lift from lowering autonomously in the case of an error.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-03
Manufacturer ATH-Heinl GmbH & CO.KG
- 5 -