ABB ACS850 Kurzanleitung Seite 14

14 Quick Start-up Guide for ACS850 with Standard Control Program
You are now asked if each constant speed selector should activate one constant speed.
No: Constant speeds 1...7 are activated by the sources selected by parameters 26.02,
26.03 and 26.04 as follows:
Source defined by
Yes: Constant speeds 1...3 are activated by the sources selected by parameters 26.02,
26.03 and 26.04 respectively.
Set the constant speed selector sources.
Enter the constant speeds.
Select the source of the speed reference signal.
Define the absolute minimum limit for the speed
reference. This limit applies for both the positive and
negative ranges.
Define the speed scaling used for the acceleration/
deceleration times. Define the acceleration/
deceleration times.
The diagram below shows the effect of parameter
19.01 Speed scaling on the acceleration/
deceleration times.
0
Note: Acceleration/deceleration times may be
automatically extended by the existing torque limits.
Downloaded from www.Manualslib.com
Source defined by
par. 26.02 par. 26.03
0 0
1 0
0 1
1 1
0 0
1 0
0 1
1 1
Speed
19.01
Acc. Dec.
22.02 or 22.03 or
22.04 22.05
manuals search engine
Source defined by Constant speed active
par. 26.04
0 None
0 Constant speed 1
0 Constant speed 2
0 Constant speed 3
1 Constant speed 4
1 Constant speed 5
1 Constant speed 6
1 Constant speed 7
26.02 Const speed sel1
26.03 Const speed sel2
26.04 Const speed sel3
26.06 Const speed1...
21.01 Speed ref1 sel
21.09 SpeedRef min abs
19.01 Speed scaling
22.02 Acc time1
22.04 Acc time2
22.03 Dec time1
22.05 Dec time2
Time