Mounting - Honeywell IDENTLOC slimline Montage, Anschluss, Anleitung

Mounting and Connection Instructions
4.

Mounting

4.1 Important information
ATTENTION!
Sensitive ferrite antennas are integrated in the housings of the sensor and the
transmission unit.
Therefore,
We generally recommend carrying out a test measurement prior to the mounting.
The procedure is described in the chapter "Teaching mode" of the mounting and
connection instructions of the EU.
4.2 Dimensions
and components
4.3 Instructions
Carefully check the following before installing the sensor and the transmission unit.
- Check whether there is enough space available for the installation of
whether it is necessary to use another bolt which is easier to mount.
- Avoid mechanical tensions
- Carry out the installation on an
means of flexible spacer rings.
- The lateral distance
- Any installation surface
fastening.
- The lateral offset
- The housings of the transmission unit and the sensor must be mounted
other.
- The connecting cable of the transmission unit may be shortened but
- Tighten the fixing screws equally but not too tight.
- Do not install the units in the immediate proximity of
IDENTLOC
avoid hard impacts high pressures
when mounting the housings.
even surface only. Uneven surfaces must be leveled up, e.g. by
to the next transmission unit must be
, even metal (e.g. aluminum section), is possible. Ensure safe
of the housings in all directions must not exceed
Locking Sensor slimline
, and
2.2
14 4.5
at least 20 mm
radio transmitting stations
distortions!
fixing
adapter
plate
plate
guide
plate
VdS sealing
sticker
sensor
both sensor parts or
.
2 mm .
parallel to each
not lengthened .
.
11