Honeywell IDENTLOC slimline Montage, Anschluss, Anleitung Seite 13

Mounting and Connection Instructions
Fastening the sensor
- Fastening the guide plate
If the position to which the guide plate is to be attached is provided
with a screw for fitting, this screw can be used for fastening.
If not, mount the guide plate using the supplied self-forming M3
screw. A bore with a diameter of 2.7 mm is required.
- Attaching the fixing plate
The fixing plate must be inserted so that there is minimum play between the adapter plate and
the bolt. The tip of the opening may point downwards or upwards (see illustration below)
depending on the bolt diameter.
The fixing plate should be in the correct position right from the beginning (deformation)!
It must be possible to freely move the adapter plate and the locking bolt synchronously to all
positions. Make sure that the adapter plate is guided properly and parallel to the locking rod
when actuating the lock. This is especially important in case of horizontally mounted adapter
plates.
adapter fixing
plate plate
both are possible
locking
bolt
IDENTLOC
window
leaf
connecting
rod
locking
bolt
fixing
plate
adapter
plate
guide
plate
transmission
unit
VdS
sticker
sensor
VdS
sticker
Locking Sensor slimline
window
frame
connecting
cable
transmission
markings
13
locking
bolt
adapter
plate
guide
plate
sensor
marking on
the frame