Teaching Mode - Honeywell IDENTLOC slimline Montage, Anschluss, Anleitung

14
Mounting the transmission unit
Transfer the transmission marking of the sensor to the window
frame.
Draw the lateral distance.
We recommend making the cable bore first. Move the transmission
unit to the corresponding position and fasten it by means of an
adhesive tape.
Now, carry out a functional test according to the chapter "Teaching
mode" of the mounting and connection instructions of the
evaluation unit.
ATTENTION!
Make sure that the transmission unit only signals a closed state if
at least half (50 %)
inserted in the anchor of the fittings. If not, change the position of
the transmission unit until the condition is fulfilled. (It might be
necessary to widen the cable bore.)
Make the fixture bores only after having completed the functional
test successfully.
(See mounting and connection instructions of the transmission
unit.)
The sensor housing can be moved to the left or right if it is necessary
to correct the lateral position.
Loosen the fixing screw of the sensor slightly, put the sensor to the
correct position and tighten the screw (not too tight).
5.

Teaching mode

An individual data code is assigned to each sensor which makes it necessary to read this code
in the evaluation unit in the teaching mode.
This means that the codes of the sensors must be read in by the evaluation unit in the teaching
mode after each new installation or sensor modification.
The teaching mode is described in detail in the mounting and connection instructions of the
evaluation unit, chapter "Teaching mode"
Mounting and Connection Instructions
of the locking bolt of the locking system is
IDENTLOC Locking Sensor
lateral
distance
centre
transmission
marking
(5.5 mm offset
to the centre)
slimline