Connection With The Mains; Connection Between Devices; Operation; Stand-Alone Mode - EuroLite LED IP CCR-600 QCL Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the power plug. The occupation of the connection cables is as follows:
The occupation of the connection-cables is as follows:
Cable
Brown
Blue
Yellow/Green
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

Connection between devices

On the rear panel, there is a socket (Power Out). Connect the output with the mains input of the next fixture
until all fixtures are connected.
Please note: A maximum of 8 devices may be linked together. After every 8 devices, the fixtures
Please make sure that open contacts are closed with caps in order to avoid humidity and dirt in the
device.

OPERATION

After you connected the effect to the mains, the LED IP CCR-600 QCL starts running.
The LED display lights up and you can now choose the desired settings via the buttons MODE, UP, DOWN
and ENTER.
The device has two operating modes. It can be operated in stand-alone mode or in DMX-controlled mode via
any standard DMX controller.

Stand-alone Mode

In the stand-alone mode, the LED IP CCR-600 QCL can be used without DMX-controller. Disconnect the
LED IP CCR-600 QCL from the DMX-controller.
Downloaded from www.Manualslib.com
Pin International
Live L
Neutral N
Earth
must have a renewed connection with the power mains.
manuals search engine
22/28
00096946.DOCX, Version 1.0