How To Use; Regulating The Motion Sensitivity; Regulating The Sensitivity Of The Light; Regulating The Duration Of The Illumination - LIVARNO LUX Z30649A Montage-Und Sicherheitshinweise

How to use / Cleaning and care

How to use

Q
note: The light has a motion sensor that reacts to
temperature changes. The sensor works best at an
ambient temperature below 20 °C. A moving object
at a temperature close to the ambient temperature
is only detected with great difficulty.
note: The controls are at the front of the lamp,
above the motion sensor
The range of the motion sensor
(+ / -1 - 2 m) if the lamp is installed at a height of
1.80 to 2.50 m (Fig. H). It has a roughly 100°
detection radius (Fig. I).
regulating the
Q
motion sensitivity
j
O pen the hinged lid
operate the control to regulate the motion
sensitivity .
6
j
T urn the control to regulate the motion sensitivity
clockwise to increase the range of the motion
6
sensor .
8
j
Turn the control to regulate the motion sensi-
tivity anti-clockwise to decrease the range
6
of the motion sensor
regulating the sensitivity
Q
of the light
j
O pen the hinged lid
operate the control for light sensitivity
j
T urn the control to regulate the light sensitivity
clockwise to increase the sensitivity of the light.
j
T urn the control to regulate the light sensitivity
anti-clockwise to decrease the sensitivity of the
light.
note: When the lamp is switched on, the light
sensitivity sensor is switched off so that even despite
the brightness from the light movements can still be
detected.
6 GB
(Fig. A).
8
is approx. 6 - 8
8
in order to be able to
9
.
8
in order to be able to
9
.
7
7
regulating the duration
Q
of the illumination
The amount of time the light stays on can be set to a
value between approx. 4 - 5 and 240 - 300 seconds.
j
O pen the hinged lid
operate the control to regulate duration of light
.
5
j
T urn the control to regulate the duration of the
illumination
5
tion of the illumination.
j
T urn the control to regulate the duration of the
illumination
5
duration of the illumination.
note: After the motion detector has switched the
light on, the light will stay on for the set period of time.
If during this period a new movement is detected,
the time the light stays on for will be extended by
the set period of time.

replacing the illuminant

Q
j
M ake sure that the lamp is dead, i.e. not live.
To do so, remove the fuse or move the switch
of the fuse in your sub-distribution to "0".
j
T he lamp can get very hot when in use. If nec-
essary, allow the lamp to cool down for about
15 minutes.
j
R emove the lamp shade
ring by screwing the lamp shade
3
the lamp housing
j
R emove the illuminant
j
I nsert a new illuminant with a suitable base
and of an appropriate wattage (see section on
"Technical data").
j
S crew the lamp shade
7
body .
4
j
S witch the electrical power back on.
in order to be able to
9
clockwise to increase the dura-
anti-clockwise to decrease the
and the sealing
1
1
.
4
from the base.
2
back onto the lamp
1
out of