Safety Information; Technical Data; Proper Use; Before Starting Up - EINHELL LH 2541/1 Bedienungsanleitung

Anleitung LH 2541-1_SPK7:_
1. Important information
Please read the directions for use carefully and
observe the information provided. It is important to
consult these instructions in order to acquaint your-
self with the machine, its proper use and safety pre-
cautions.
Keep these instructions in a safe place.
Improper operation of the electric garden refuse
shredder can lead to serious injuries.
This electric garden refuse shredder is designed only
for shredding organic garden waste.
Important!
For safety reasons, the electric garden refuse
shredder may not be operated by individuals
under 16 years of age.

2. Safety information

The corresponding safety information can be
found in the enclosed booklet.

3. Technical data

Voltage: 230 V ~ 50 Hz
Power rating: 2500 W (S6-40%)
2000 W (S1)
Cutting unit idling speed
Branch diameter: max. 40 mm
L sound pressure level:
pA
L sound power level:
WA
Weight:
S6 (40%) stands for a duty cycle based on 4 minutes
on-load and 6 minutes off-load operation. Maximum
power consumption depends on the consistency of
the material being shredded.
4. Layout of the (Figure 1)
1 Funnel inlet
2 Motor protection switch
3 ON/OFF switch
4 Switch for selecting the direction of rotation
5 Integral mains plug
6 Knob for setting the counter blade
11.01.2007 15:41 Uhr
7 Chassis
8 Discharge opening

5. Proper use

This electric garden refuse shredder is designed only
for shredding organic garden waste. Place biologi-
cally degradable material, e.g. leaves, branches,
dead flowers etc., into the loading funnel inlet.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Collecting the shredded material
A container can be placed underneath the ejector
opening to catch the shredded material.

6. Before starting up

6.1 Assembly (Fig. 2)
Take all the parts out of the packaging.
Fit the chassis to the housing using the two lock
nuts (item 2). Use the assembly tool provided for
this purpose.
Fit the axle (item 3) to the chassis using the two
M6 x 50 screws (item 4) and nuts (item 2). Use the
assembly tool provided for this purpose.
Push the wheels (item 5) on to the axle.
Secure the wheel cover (item 6) on the axle using
a hammer.
40 min -1
7. Starting up
79 dB (A)
91 dB (A)
7.1 ON/OFF switch (Fig. 1 / item 3)
26 kg Press the green knob to switch on the shredder.
Press the red knob to switch it off.
Important: The machine has a zero voltage switch.
This prevents the machine restarting unintentionally
after a power failure.
7.2 Switch for selecting the direction of rotation
(Fig. 1 / Item 4)
Important! The switch for selecting the direction
of rotation can only be moved when the shredder
is switched off.
Seite 7
GB
7