Operation - Vitek VT-1666 Betriebsanweisung

from the operating chamber. Check the
oven whether there is deformation or not.
Pay special attention to the door state. If
there is some problem do not set and do
not switch on the oven.
Protective covering
Case: If there is protective covering, re-
move it from the surface.
Do not remove light grey mica plate in-
side the operating chamber; it serves
to protect the magnetron.
Setting the glass tray
1. Set the rotating socket (6) in the open-
ing situated on the bottom of the operat-
ing chamber.
2. Set the roller ring (7) on the bottom of
the chamber.
3. Carefully set glass tray (3) on the roller
ring (7), by matching ledges and grooves
of the support (6).
Never set the glass tray with its bottom
upside down.
• Do not prevent rotation of the glass tray
while operating the oven.
• During cooking always use glass tray
and tray support.
• Products and cookware should be al-
ways set only on the glass tray.
• The glass tray can rotate clockwise/anti
clockwise. It is normal.
• If cracks or chops appear, stop using
the unit immediately or replace the glass
tray.

OPERATION

• Before switching on the unit, make sure
that the voltage in your home socket
corresponds to the voltage specified on
the unit.
• Put the products inside the working
chamber and close the door.
Sound signal
Pressing buttons on the control panel or
1666.indd 7 1666.indd 7
turning the handle you will hear sound sig-
nals.
After the cooking is finished you will hear 4
sound signals and in every two minutes you
will hear repeated sound signals reminding
you to open the door of the microwave oven
and take out the product.
Setting current time
Insert the power plug into the socket, you
will hear a sound signal, "1:01" will appear
on the display. Press the "clock" button
once or twice, to select 12-hour or 24-hour
format.
Example: to set current time 8 hours 30
minutes.
1. Press the "сlock" button once.
2. Turn the "time/menu" knob clockwise,
and set hours - 8.
3. Press the "сlock" button to confirm.
4. Turn the "time/menu" knob clockwise
and set minutes - 30, 8:30 will be dis-
played.
5. Press the "сlock" button to confirm.
The preset time will be displayed, the (26)
indication will appear on the display, and
the dots (20) will be flashing.
Note: if time setting is not finished, then
in about 30 seconds a sound signal will
be heard and display information will
reset to default settings.
During cooking of products to display
the current time press the "Clock" but-
ton the current time will be displayed dur-
ing 5 seconds.
Cooking in a microwave oven
To switch the microwave cooking mode,
press the "Power" button for several times
to set the required power level and then by
turning the "Menu/Time" knob clockwise
set the required cooking time.
Max. Cooking time is 60 minutes.
7
ENGLISH
24.06.2008 12:46:29 24.06.2008 12:46:29