Shutting Down; Transport; Storage; Care And Service - Kärcher BDS 43/Orbital C Originalbetriebsanleitung

system, cleaning solution is applied from 2
nozzles in front of the device.
1. Set the spray switch to "ON".
Adjusting nozzles
1. Loosen the clamping screw.
2. Align the nozzle.
3. Tighten the clamping screw.

Shutting down

1. Pull the mains plug out of the socket.
2. Pull the tilt adjustment lever up and hold
it in position.
3. Bring the handle into a vertical position.
4. Release the tilt adjustment lever.
5. Remove the remaining cleaning solution
from the detergent tank.
6. Rinse the detergent tank with clear wa-
ter.
7. BDS 43 / Orbital C Spray only: Rinse
the spray system with clear water.
8. Wind the mains cable onto the cable
holders.
9. Swing the cleaning head upwards by lift-
ing at the handle.
Illustration O
Handle
1
Cleaning head
2
10.Remove the pad from the pad drive
board.
11.Clean the device with a moist cloth.

Transport

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
1. Pull the tilt adjustment lever and position
the handle vertically.
2. Release the tilt adjustment lever.
3. Tilt the device back and transport to the
destination.
4. When transporting in vehicles, secure
the device against rolling away, slipping
and tipping according to the respectively
applicable guidelines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transport and storage.
1. Store the device indoors only.
2. To protect the pad drive plate, swivel the
cleaning head upwards by lifting the
handle.
Illustration O
Handle
1
Cleaning head
2

Care and service

WARNING
Risk of injury
The device may start up unexpectedly.
Be sure to pull the mains plug out of the
socket before you start working on the de-
vice.
1. Wash dirty pads at a maximum of 60 °C.
2. Clean the casing of the device with a
damp cloth and then rub dry.
3. Check the mains cable for damage.

Troubleshooting guide

WARNING
Risk of injury
The device may start up unexpectedly.
Be sure to pull the mains plug out of the
socket before you start working on the de-
vice.
In the event of malfunctions that cannot be
remedied using the following information,
please contact customer service.
Unsatisfactory cleaning results
 Replace dirty pad.
 Replace worn pad.
 Check the suitability of the detergent
used for the application.
 Check the suitability of the pad used for
the application.
The device vibrates strongly
 Check for central positioning of the pad
on the pad drive board.
 Check attachment of the pad.
English

Storage

15