Ottobock 10V39 Gebrauchsanweisung Seite 16

6.1 Rotation
The 10V39=* MovoWrist Flex unlocks for rotation by pressing the push button
1 (fig. 3). It can be freely positioned in 20 different engaging points. When
the push button 1 is released in an engaging position, the wrist unit will lock.
6.2 Exchange
The push button 2 (fig. 3) unlocks the wrist unit for exchange of the sys-
tem hands, cable-activated hook or terminal device. The system hand,
hook or terminal device ejection is supported by a spring integrated in the
10A30=* Adapter.
Should a new terminal device be adapted, it must be slid into the wrist unit
while locking is performed automatically.
6.3 Flexion
The push button 3 (fig. 3) releases flexion and extension of the 10V39=*
MovoWrist Flex for positioning in 5 lock positions. After releasing the push
button 3, the terminal device will lock in one of the flexion lock positions.
7 Mounting instructions MovoWrist Flex 10V39
7.1 Mounting MovoWrist Flex 10V39
The mechanics of the wrist unit must be separated from the lamination
ring with Allen wrench size 3 (fig. 4). In order to avoid soiling the lamina-
tion ring in the subsequent steps, replace the included protective cover
with slight pressure (fig. 5). The flexion level of the mechanics is indicated
on the lamination ring by a notch (fig. 2). Bring the lamination ring in the
forearm socket into the correct position according to the course of flexion.
Mark the position of the notch on the forearm socket (fig. 6). To create a
firm connection with the lamination ring, roughen the bonding surface on
the inside of the forearm socket. Mark the 20-mm height of the lamination
ring on the lower arm (fig. 7). Clean the bonding surfaces on the lamina-
tion ring and lower arm with acetone. After cleaning, let the acetone air
dry and do not touch the bonding surfaces. Mask the outside of the lower
arm off using Polyethylene Adhesive Tape 627B4 to avoid soiling it while
gluing. Mix Orthocryl® Sealing Resin Compact Glue 636K18=1 and Hard-
ener Paste 617H14 in accordance with the manufacturer's specifications.
Apply sealing resin on the lamination ring and lower arm (fig. 8) and flush-
align the lamination ring with the lower arm. Make sure that the notches
in the lamination ring are flush with the marking on the lower arm made
16 | Ottobock