Safety Instructions; Electrical Connection - Electrolux EWF 1484 EDW Benutzerinformation

4 www.electrolux.com
•
•
•
•
•

2. SAFETY INSTRUCTIONS

2.1 Installation
• Remove all the packaging and the
• Keep the transit bolts. When you move
• Always be careful when you move the
• Do not install or use a damaged
• Obey the installation instruction
• Do not install or use the appliance
• Make sure that the floor where you
• Make sure that there is air circulation
• Adjust the feet to have the necessary
• Do not install the appliance where the

2.2 Electrical connection

• The appliance must be earthed.
Downloaded from www.Manualslib.com
The appliance is to be connected to the water mains
using the new supplied hose-sets. Old hose sets must
not be reused.
If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
Before maintenance, deactivate the appliance and
disconnect the mains plug from the mains socket.
Do not use water spray and steam to clean the
appliance.
Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
transit bolts.
the appliance again you must block the
drum.
appliance because it is heavy. Always
wear safety gloves.
appliance.
supplied with the appliance.
where the temperature is less than 0
°C or where it is exposed to the
weather.
install the appliance is flat, stable, heat
resistant and clean.
between the appliance and the floor.
space between the appliance and the
carpet.
appliance door can not be fully
opened.
manuals search engine
• Always use a correctly installed
shockproof socket.
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
mains plug and to the mains cable.
Should the mains cable need to be
replaced, this must be carried out by
our Authorised Service Centre.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
• Do not touch the mains cable or the
mains plug with wet hands.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
• Only for UK and Ireland: The appliance
has a 13 amp mains plug. If it is
necessary to change the fuse in the
mains plug, use a 13 amp ASTA (BS
1362) fuse.
• This appliance complies with the E.E.C.
Directives.