7
In the configuration menu it is possible to change various positioner parameter values. To
reach the configuration menu the parameter "C: CONFIG" must be selected in the working
level and then the
value appears in the top line, the name and number of the parameter appear in the bottom
line. Operation is as shown below.
7.1
PRESS -> FOR 3s
C: CONFIG
7.2
Press -> For 3s
C: CONFIG
Downloaded from
www.Manualslib.com
Configuring (C: CONFIG)
button must be kept pressed for more than 3 seconds. The parameter
Parameter setting for new positioners (from software V2.0.0.0)
press for more
länger als 3s drücken
than 3 seconds
1: SETPOINT
<-
OK
<-
->
<-
->
<-
OK
1: SETPOINT
Parameter setting for old positioners (up to software V1.3.1.8)
0..10V
1: SETPOINT
4..20mA
1: SETPOINT
0..20mA
1: SETPOINT
manuals search engine
4...20 mA
2: INIT ALL
PRESS -> FOR 3s
[ 4...20 mA]
2: INIT ALL
ESC
[ 4...20 mA]
+
-
[ 0...10
V
]
+
-
[ 0...10 V]
ESC
0...10 V
NO INIT
2: INIT ALL
PRESS -> FOR 3s
2: INIT ALL
21 / 24
NO INIT
DEFAULT
3: DEFAULT STATE
PRESS -> FOR 3s
3: DEFAULT STATE
DEFAULT
3: DEFAULT STATE
PRESS -> FOR 3s
3: DEFAULT
1435 ePos
...
RISE
11: X-DIRECTION
FALL
11: X-DIRECTION
®