Bestway Lay-Z-Spa Handbuch Seite 13

PRCD Test
RESET
RESET
TEST
1
NOTE: Drawings for illustration purpose only. May not
reflect actual product. Not to scale.
1. Insert the plug.
2. Press the "RESET" button, the indicator light turns on.
3. Press the "TEST" button, the indicator light turns off.
4. Press the "RESET" button, the indicator light turns on.
5. Press the "On/Off" button for 2 seconds, your pump is ready to use.
WARNING: The PRCD plug must be tested before each use to avoid risk of electric shock.
WARNING: Before inserting plug into a power outlet, make sure the current rate of the power outlet is suitable for the pump.
WARNING: Do not use the pump if this test fails and contact our Customer Service.
NOTE: When inflating, you will notice that air will be expelled
from the area where the air hose
connects to the pump, this is normal
for technique requirements.
NOTE: Do not use an air
compressor to inflate the pool.
NOTE: Do not drag the pool on rough ground as this may cause
damage to the pool liner.
NOTE: Inflation time for reference only.
Air Valve Check (for spa with quick inflation/deflation valve)
Always check the air valve carefully before inflation to ensure there is not an air leak.
If the air valve is loose, use the provided wrench to fasten the air valve following
these steps:
With one hand, hold the backside of the air valve from the inner side of the spa wall
and turn the wrench clockwise.
NOTE:
1. Do not over tighten.
2. Do not adjust the air valve connector when the spa is in use.
SPA PUMP EQUIPOTENTIAL BONDING TERMINAL
It is recommended to arrange for a qualified electrician to connect
the spa pump to an equipotential bonding terminal using a
minimum 2.5mm
Assembly part refer to the provided installation leaflet.
RESET
TEST
TEST
2
solid copper conductor.
2
RESET
TEST
3
4
13