Siemens SITRANS Probe LU Kurzanleitung Seite 11

Changing a Parameter Value
Notes:
• Security must be disabled to enable programming: set P000 to the Unlocked Value stored
in P069. (A remote master can still change configuration, if P799 is set to allow this.)
• Invalid entries will be rejected or limited.
• CLEAR
1.
2.
Parameter Reset to Factory Default
1.
2.
Master Reset (P999)
Returns all parameters except P000 and P069 to default settings. (The learned TVT curve is not
lost.)
1.
2.
3.
4.
5.
Quick Setup: steps 1 to 10
Note:
1. Select language (P010: Language)
Values
7ML19985QR81
Downloaded from www.Manualslib.com
can be used to clear the field.
Key in the new value.
Press ENTER to set the value.
Scroll to the parameter or enter its address.
Press CLEAR then ENTER
Press PROGRAM then DISPLAY
,
Press DISPLAY to open parameter fields.
Key in 999.
Press CLEAR then ENTER
reset. The LCD displays C.ALL.
Reset complete. (Reset takes several seconds to complete.)
Default values (factory settings) are marked by an asterisk (*) in the tables.
Numeric/None
0 *
English
1
German
2
French
3
Spanish
4
SITRANS Probe LU – QUICK START MANUAL
manuals search engine
. The value returns to the default setting.
to activate PROGRAM mode.
, to Clear All and initiate
ENGLISH DEUTSCH
P000 LOCK VERRIEGELG
P001 OPERATION BETRIEB
P003 MEAS RESP REAKTIONSZ
P004 ANTENNA ANTENNE
P005 UNITS EINHEIT
P006 EMPTY MESSBER.
P007 SPAN MESSSPANNE
P010 LANGUAGE SPRACHE
FRANÇAIS ESPAÑOL
VERROUIL BLOQUEO
FONCTIONMT FUNCIONAM.
TEMPS REP . TIEMPO R.
ANTENNE ANTENA
UNITES UNIDADES
VIDE VACIO
PLAGE RANGO
LANGUE IDIOMA
Page EN-9