Baxi LUNA HT 1.450 Gebrauchsanleitung Für Den Verbraucher Und Den Installateur Seite 76

IT
DE
GB
CZ
HU
RO
Downloaded from www.Manualslib.com
This type of installation can be carried out both on a flat or pitched roof by fitting a terminal, an
appropriate weathering tile and sleeve, (supplementary fittings supplied on demand).
L max = 10 m
... separated flue-air ducting
This type of ducting allows to disengage exhaust flue gases both outside the building and into single
flue ducts.
Comburant air may be drawn in at a different site from where the flue terminal is located.
The splitting kit consists of a flue duct adaptor (125/80) and of an air duct adaptor.
For the air duct adaptor fit the screws and seals previously removed from the cap.
Intake air duct adaptor
The 90° bend allows to connect the boiler to flue-air ducting regardless of direction as it can be ro-
tated by 360°. It can moreover be used as a supplementary bend to be coupled with the duct or with
a 45° bend.
A 90° bend reduces the total duct length by 0.5 metre.
A 45° bend reduces the total duct length by 0.25 metre.
manuals search engine
Vertical flue terminal Ø 80/125 mm installation options
L max = 10 m
76 76
L max = 8 m L max = 9 m
Intake air cap