Ending The Operation; Maintenance; Tilting The Machine; Mounting/Removing Tools - Schwamborn ES 330 Originalbetriebsanleitung

EN ES 330 / ES 430E / ES 430 / EP 430 / EP 430 duo / ES 420 /
ES 420 duo / ES 420S / ES 420SH / ES 500 / STR 580 / STR 581

4 Maintenance

3.4 Ending the operation

Observe the safety instructions in Chapter 2!
Risk of injury from tool still rotating after the
machine is switched off!
Only switch off the machine with the tool
resting on the floor!
The tool can otherwise still rotate idly (run-on)
for several seconds after being switched off or
the safety switch is released.
1. Release both safety switches [9, Fig. A].
The drive is switched off
n
2. Place the guide bar [3, Fig. A] in an upright posi-
tion (! Chapter 3.1, as of pos. 5., page 19).
The machine is switched off
n
Risk of injury from high voltage!
There is still residual voltage even after the
machine has been switched off!
The power supply has to be disconnected to
remove all voltage from the machine.
3. Pull the power plug [1, Fig. A] from the
socket.
The power line can be coiled between the han-
dle and the bracket [12, Fig. C].
4 Maintenance
Observe the safety instructions in Chapter 2!
Maintenance work may only be performed
by trained specialists! They must be familiar
with the dangers associated with such work,
protect themselves and avoid danger!
When working on the machine (set-up, main-
tenance, service, repair, cleaning, etc.), the
power supply of the machine has to be dis-
connected from the mains
(Pull the power plug from the socket)!
Perform cleaning and maintenance work in
accordance with the operating manual and
check the safety equipment for complete-
ness and functionality!

4.1 Tilting the machine

The horizontal position is intended for tool
changes, maintenance and transport.
Before tilting the machine, always make sure
that it is on an even, level floor surface!
1. Pull the power plug [1, Fig. A] from the
socket.
2. Swivel and lock the guide bar [3, Fig. A] into
vertical position
(! Chapter 3.1, page 18).
3. If necessary, press the watering lever [11, Fig. C]
and empty the tank [18, Fig. E].
4. Tip the machine backwards and place it on the
floor (! Fig. F).

4.2 Mounting/Removing tools

There are many different tools and accessories avail-
able from the manufacturer that are tailored to the
machine for cleaning, polishing, crystallising, strip-
ping, shampooing, and wet and dry grinding.
The consistency of the surface to be treated deter-
mines the type or composition of the tools to be used.
21