Le Chai LM78 Bedienungsanleitung Seite 79

Setting the Temperature Control
When the unit is plugged in for the first time, the unit will power up automatically to the preset defaults.
The preset temperature at the factory for UPPER temperature zone is 10ºC (50ºF) and for LOWER
temperature zone is 16ºC (60ºF).
You can press the left side UP and DOWN keys to control the internal temperature of the UPPER
temperature zone and press the right side UP and DOWN keys to control the internal temperature of the
LOWER temperature zone. When you press either key at the first time, the display will show the last
temperature set previously.
IMPORTANT: The temperature set for the LOWER temperature zone must always be just as high as or
higher than that in the UPPER temperature zone. For optimal performance, the set temperature of the
two zones should differ by at least 4°C (7F°).
The temperature that you desire to set will increase 1ºC or 1ºF if you press the UP key once, on the
contrary the temperature will decrease 1ºC or 1ºF if you press the DOWN key once. The display flashes
while you make the setting.
After the temperature has been set, the display shows the current inner temperature of the particular
temperature zone.
To view the set temperature at any time, press the UP or DOWN key, the set temperature will
temporarily flash in the display for 5 seconds. Then the display shows the current inner temperature
again.
TEMPERATURE MEMORY FUNCTION
In the event of a power interruption (power surge, breaker switch, etc.), the unit remembers the previous
temperature settings. When the power is recovered, the cabinet temperature will go back the same
setting temperature as before the power interruption.
TEMPERATURE ALARM
An audible alarm will sound if the temperature in one of the zones rises or falls outside the temperature
range. The relevant temperature display will flash at the same time. The temperature the appliance is set
at determines the temperature the appliance recognizes as being too warm or too cool. The audible
alarm will sound and the temperature display will flash:
- When you switch the appliance on, if the temperature inside the appliance is very different from the
temperature set.
- When there has been a lengthy interruption to the power supply.
- When too many items have been put into the unit at one time. Or too much ambient air flowed in when
rearranging and removing storage items.
- When the door is not been closed tightly.
- The appliance is faulty.
The audible alarm will be automatically silenced and the temperature display stops flashing when the set
temperature is reached again. However, if the noise disturbs you, you can switch the audible alarm off
before this if you wish by pressing the POWER key once. The alarm will stop. The relevant temperature
display continues to flash until the set temperature has been reached. The display then lights up
constantly, and the alarm system is fully active again.
DOOR ALARM
If the door has been left open for more than 60 seconds, the audible alarm will sound. Closing the door
or pressing the POWER key once can switch off the audible alarm.
INTERIOR LIGHT
The interior light makes it easy to view your wine labels and enhances the display of your collection.
Touching the LIGHT mark toggles between 2 modes of operation for the internal lights: functional
(default) mode and showcase mode. If you are in functional (default) mode, the lights will turn on only
when the door is open. If you are in showcase mode, the lights will be on whether or not the door is
open. The unit is equipped with a LED light fitting system. To change the LED light fitting pls contact the
service department.
NOTE: Please use only the original LED light fittings provided by the manufacturer.
79