cecotec Conga 3790 Bedienungsanleitung Seite 36

ENGLISH
Edge mode
Select this mode for the robot to clean along walls and furniture.
It can be activated from the App or the remote control.
Spiral mode
When this mode is selected, the robot will start cleaning in a specific point, and then will clean
carrying out moves in spiral motion outwards.
It can only be activated from the App.
Scrubbing mode
When this mode is activated, the robot moves in a swaying motion, simulating real scrubbing
moves. It starts off cleaning in Edge mode, then in zigzag motion and finally returns to the
charging base taking the straightest way back home.
It can only be activated from the App.
Manual mode
To carry out manual cleaning, use the direction buttons on the remote control or on the App to
take the robot to the specific points where you want it to clean.
It can be activated from the App or the remote control.
Back home mode
Select this mode at any point of any cleaning cycle and during any of the modes, the robot will
automatically return to the charging base.
It can be activated from the robot, the remote control or the App.
Smart Area mode
Once the home's map has been saved, select this mode for the robot to clean a specific area
in zigzag motion. The robot will clean the selected area and then will return directly to the
charging base. You can set more than 1 area at the same time. The robot will only clean the area
selected in the map, therefore it will go to the point and return to the base without vacuuming.
It can only be activated from the App.
Spot mode
Select this mode if you want to thoroughly clean a specific point in the map, making the most
of the robot's maximum power. The robot will clean a 2x2 m zone in zigzag motion and then
will return directly to the charging base when cleaning is completed. The robot will only clean
the area selected on the map, therefore it will go to the point and return to the base without
vacuuming.
It can only be activated from the App.
Restricted area mode
35