Setting The Time - Terraillon MultiThermo Gebrauchsanweisung

049558_Multithermo_4 13/04/05 18:30
Sensor
cover
Sensor
"On" button
Time set
button
Button
to open battery
compartment
Stand
Battery
compartment
cover
USING YOUR
THERMOMETER FOR
THE FIRST TIME
The device is supplied with a 3V battery
(CR2032) already in place, so it is ready
to use.

SETTING THE TIME

The first time you use this thermometer
or after changing the battery, you have
to set the time.
Open the battery compartment using the
tip of a biro. Press the time set button.
The hour numbers flash. Press the 'on'
button of the thermometer to set the
10
Page 2
hour. Confirm by pressing the time set
button. The minute numbers flash.
Press the 'on' button of the thermometer
to set the minutes. Confirm by pressing
the time set button.
On standby, the screen will alternately
display the ambient temperature and the
time.
TAKING
TEMPERATURES
With its protective cap on, the device
is in forehead mode by default. When
the protective cap is removed, the
thermometer automatically switches to
ear mode.
1. Forehead
Press the temperature reading button.
There is a beep, then the latest tempe-
rature in the memory is displayed. Press
the temperature reading button and keep
it depressed. Place the sensor on one
of your temples. Slide the sensor
across your forehead to the other
temple. Release the button to stop the
measurement. There is a beep and your
temperature is displayed.
*The forehead temperature shown
corresponds exactly to the oral
temperature.
The forehead temperature can be
subject to the influence of outside
climatic conditions. In case of doubt,
do not hesitate to take the temperature
in the ear.
2. Ear
Remove the protective cap. The device
automatically switches to ear mode.
Press the temperature reading button.
There is a beep indicating that the device
CHANGING
is ready, then the latest temperature in THE BATTERY
the memory appears. Press the tempe-
When the "
rature reading button and keep it
the screen, this means that the battery is
depressed. Inser t the sensor in the
running low. When the screen displays
auditory canal until a beep informs you
" " , this means that the battery has run
that the temperature reading is finished.
out and has to be changed.
Release the button. Remove the sensor
from the ear. Your temperature is
displayed.
Important: In order to get an accurate
measurement, make sure that you
position the sensor in the ear correctly
so that the tip of the sensor picks up
the heat generated by the eardrum.
To do this, you can pull the ear to
straighten the canal and turn the sensor
slightly inside (For users under the age
Button to open
battery compartment
of 1, pull the ear backwards gently; for
children over 1, pull the ear up and
back).
Open the battery compar tment by
pressing the button on the back of the
Eardrum
device with the tip of a pen. Remove the
used battery.
Pinna
Replace it with a 3V lithium CR2032
battery, inserting it into the designated
space.
Auditory canal
The widest part of the battery must be
on top. The "+" must remain visible
once the battery is in place.
Replace the cover. The device is ready
to use.
(Do not throw away used batteries.
Put them in a special container
for collection and recycling).
" symbol appears on
11