Mark Infra ER 2600W Technisches Handbuch Seite 9

3.5 Remote control instructions
1. POWER BUTTON: Turn the heater off.
2. UP BUTTON: Increase timer and level.
3. DOWN BUTTON: Decrease timer and level.
4. LEVEL BUTTON: Use to adjust the heat levels (L1-L2, L1 50% power, L2 100% power).
Press the Level button then use the up and down buttons(buttons 2 and 3) to increase or
decrease the heating level.
5. TIMER BUTTON: To set the timer from 0H-24H, which is the number of hours it will run.
0H will display and then adjust to the number of hours you would like to set, using the up
and down buttons(2 and 3).
Noted: All MARK Infra ER electric radiant panels and their remote controls have the same
frequency, so it is possible to control several heaters with just one remote.
PUSH BUTTON: on the right end of heater, it could be manually operated without remote
control.
3.5.1 Inserting batteries
Insert 2 AAA/ Alkaline type batteries into your remote control
1. Flip the backside of your remote control and pull out battery cover. Insert the batteries in
accordance with the instructions and polarity.
2. Change the batteries in the same way depicted above.
NOTICE:
1. Replace the old batteries with the same type batteries. Otherwise, your heater may not
function well.
2. Pull out the batteries in case of long terms of disuse to prevent leakage which may impair
your remote control.
3. Do not allow water or liquid to get into the remote control.
Remote Control Function
Button Function
(Heater ON)
1 Turns heater on or off
2 Increase Heat Level
or Timer hours
3 Decrease Heat Level
or Timer Hours
4 Enable Heat Level
adjustment
5 Enable Timer
adjustment
Function LED Display
(Heater OFF) on Heater
Turns heater on to L1
Level 1 (minimum)
Turns heater on to L2
Level 2 (Maximum)
L [n]
0-24 [0H]-[24H]
EN
9 9