Technical Data; Vibration Information; Working Instructions; English - Milwaukee M18 FMDP Originalbetriebsanleitung

TECHNICAL DATA

Magnetic core drilling machine
Production code
Battery voltage
No-load speed
Stroke
Max. magnetic power
Spindle receiver
Drill diameter max. with core hole drill bit
Drill diameter max. with solid drill bi
Weight according EPTA-Procedure 01/2003 ( Li-lon 5,0 Ah)
Noise information
Measured values determined according to EN 61029. Typically, the A-weighted noise levels of the tool are:
Sound pressure level (Uncertainty K=3dB(A))
Sound power level (Uncertainty K=3dB(A))
Wear ear protectors!

Vibration information

Vibration total values (triaxial vector sum) determined according to EN 61029
Vibration emission value a
h
Uncertainty K=
WARNING
The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 61029
and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications,
with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over
the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running
but not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories,
keep the hands warm, organisation of work patterns.
WARNING!
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY WARNINGS MAGNETIC CORE DRILLING
MACHINE
Always use the protective shields on the machine. Use protective
equipment. Always wear safety glasses when working with the
machine. The use of protective clothing is recommended, such as
dust mask, protective gloves, sturdy non-slip footwear, helmet and
ear defenders.
Never reach into the danger area of the machine when it is running.
Sawdust and splinters must not be removed while the machine is
running.
Do not use a damaged accessory.
Clamp or otherwise secure the workpiece. To reduce the risk of
injury, do not hold workpiece by hand.
WARNING! Wet connections are shock hazards.
Do not use cutting fluid in an overhead or any other position that
allows cutting fluid to enter motor or switch enclosure.
SPECIFIED CONDITIONS OF USE
The drill stand is suited for drilling large holes in steel and other
ferroginous metals.

WORKING INSTRUCTIONS

The electromagnetic drill press attaches magnetically to 6,35 mm
or thicker ferrous stock. Do not use on stock less than 6,35 mm. The
magnetic base WILL NOT hold on nonmagnetic grades of stainless
steel.
The substrate under the drill stand has to be clean, firm, smooth,
dry, without polish and not have any holes in it.
Do not expose the drill stand to rain and do not use in damp or
non-flameproof rooms.
Keep constant pressure throughout the entire operation to prevent
chips and burrs from falling under the cutting edges. Cutting debris
under the cutter can make cutting difficult or impossible.
M18 FMDP
4521 54 01...
... 000001-999999
18 V
400 min
-1
690 min
-1
146 mm
8,89 kN
19 mm Weldon
38 mm
13 mm
13 kg
82,4 dB(A)
93,4 dB(A)
1,69 m/s
2
1,5 m/s
2

English

19
GB