Technical Data; Specified Conditions Of Use - Milwaukee M18 FMDP Originalbetriebsanleitung

TECHNICAL DATA

Magnetic core drilling machine
Production code
Battery voltage
No-load speed
Lengths of stroke
Max. magnetic power
Spindle receiver
Drill diameter max. with core hole drill bit
Drill diameter max. with solid drill bit
Weight according EPTA-Procedure 01/2003 ( Li-lon 5,0 Ah)
Noise information
Measured values determined according to EN 62841. Typically, the A-weighted noise levels of the tool are:
Sound pressure level (Uncertainty K=3dB(A))
GB
Sound power level (Uncertainty K=3dB(A))
Wear ear protectors!
Vibration information
Vibration total values (triaxial vector sum) determined according to EN 62841
Vibration emission value a
Uncertainty K=
WARNING
The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 62841
and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the tool is used for different applications,
with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over
the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running
but not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories,
keep the hands warm, organisation of work patterns.
WARNING!
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool.Failure to follow
the warnings and instructions may result in electric shock, fire and/
or serious injury.
Save all warnings and instructions for future reference.
MAGNETIC CORE DRILLING MACHINE SAFETY
WARNINGS
Always use the protective shields on the machine. Use protective
equipment. Always wear safety glasses when working with the
machine. The use of protective clothing is recommended, such as
dust mask, protective gloves, sturdy non-slip footwear, helmet and
ear defenders.
Never reach into the danger area of the machine when it is running.
Chips and splinters must not be removed while the machine is
running.
Do not use a damaged accessory.
Clamp or otherwise secure the workpiece. To reduce the risk of
injury, do not hold workpiece by hand.
English
20
h
WARNING! Wet connections are shock hazards.
Do not use cutting fluid in an overhead or any other position that
allows cutting fluid to enter motor or switch enclosure.
WARNING! To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your tool, battery
pack or charger in fluid or al-low a fluid to flow inside them.
Corrosive or conductive fluids, such as seawater, certain industrial
chemicals, and bleach or bleach containing products, etc., Can
cause a short circuit.
Use only System M18 chargers for charging System M18 battery
packs. Do not use battery packs from other systems.
Never break open battery packs and chargers and store only in dry
rooms. Keep dry at all times.

SPECIFIED CONDITIONS OF USE

The drill stand is suited for drilling large holes in steel and other
ferroginous metals.
M18 FMDP
4521 54 03...
... 000001-999999
18 V
400 min
-1
690 min
-1
146 mm
8,89 kN
19 mm Weldon
38 mm
13 mm
13 kg
82,4 dB(A)
93,4 dB(A)
1,69 m/s
2
1,5 m/s
2