Carson Reflex Wheel ultimate touch 2.0 Betriebsanleitung Seite 65

RX setup
Set up the receiver. RX setup menu are like the picture
• Bind with a receiver: the transmitter enters in bind mode.
Once the receiver correctly bound, press the back button to
return to normal operation (picture
• RX battery monitor: monitors the receiver battery voltage
(picture ).
• External sensor: do not monitor the receiver power supply
voltage but use an external sensor instead. This is useful when
Selecting a transmission system:
• select the correct standard
• the correct transmission standard compatible with the receiver
is selected here
• factory setting "AFHDS 2A"
Downloaded from www.Manualslib.com
).
manuals search engine
the receiver is powered by an ESC. Connect the external sensor
.
directly to the main battery.
• Low voltage: set the minimum voltage when the battery is
almost empty (picture
• Alarm voltage: set the voltage under which an audible alarm
rings and the receiver battery icon in the top tray blinks.
• High voltage: set the maximum voltage when the battery is
full.
).
65 // GB