Carson Reflex Wheel ultimate touch 2.0 Betriebsanleitung Seite 62

Race timer
When the brake side operation is unnecessary with a boat and
some other vehicle, it can be disabled.
In Ihis example, the throttle trigger is at its neutral position but
since the boat mode is activated, the throttle servo is at its low
end point.
The race timer allows to measure time durations in 4 different
modes. Touch the mode button to select the race timer mode.
• Up-Timer: this timer starts to count up from 0. It can be only
started, stopped or reset to zero.
• Down-Timer: when the down timer is stopped, the wheel sets
the start time from 1 to 99 minutes.
Once started, the down timer counts down toward zero. Once zero
is reached, it counts up Iike an up timer. Resetting a down timer
sets it back to its start time.
• Lap timer: the lap timer is an up timer. Once started, the start
button becomes the lap button.
Each time the lap button is touched, the time elapsed since the last
lap or the timer start is displayed for 3 seconds and recorded in the
lap memory. To avoid glitches, the minimum lap time is 3 seconds.
• Lap memory: this mode displays the list of the last 100
recorded lap times. If the lap timer is still running and a push
button is assigned to the race timer lap function, the lap
memory is updated each time that push button is pressed and
displayed in real time. Touching the default button erases the
lap memory. A confirmation is requested.
The race timer start/stop/lap function be assigned to a push
button.
The race timer reset function can be assigned to a push button.
GB // 62
Downloaded from www.Manualslib.com manuals search engine
In this example, the up timer
is started.
In this example, the lap button was just touched and the last lap
time is displayed for 3 seconds.
In this example, 6 laps of around 15 seconds each have been
recorded.
In Ihis example, the down
timer is set to 5 minutes but is
still stopped.