Carson Reflex Wheel ultimate touch 2.0 Betriebsanleitung Seite 47

Telemetry module FS-CVT01
Battery voltage recognition module
Procedure:
1. Connect the 3-pin connector to the "Sens" port on the receiver
or, if using more than one telemetric module, to the "IN" port on
another module.
2. Switch on the transmitter and the model (receiver). "Ext.
voltage4: 12.40V" will now be displayed on the main screen,
which means that the installation was successful.
Warning!!!
The polarity of the red and black connectors must never be
reversed. Doing so would damage the electronic components.
Example: "Ext.voltage4: 12.4V" is displayed on the transmitter
Downloaded from www.Manualslib.com
+
manuals search engine
x
3. Next, connect the red and black contact connector to the
balancer terminal of your LiPo driving battery. The red
connector is for the positive terminal and the black for the
negative terminal (outermost black cable on the balancer
connector, see diagram).
screen. This is the current voltage value of your LiPo battery which
is connected to the sensor module.
47 // GB