Energy Manager Power Supply - ECOFOREST ecoSMART e-manager Installerhandbuch

2.4.

Energy manager power supply

The ecoSMART e-manager power supply requires a single phase power supply L/ N / PE, 230 V / 50 Hz. The recommended section
of the wires for the power supply is 1.5 mm2.
For the electrical installation, bring the power cable to the upper left of the box and route it to the power terminal block as shown
below.
POWER SUPPLY
The e-manager controller is powered by an alternating current at 24V. The electrical box includes a transformer and the
overcurrent protections needed to protect your equipment.
If you are forced to replace any of the protection fuses present in the box, do it with a fuse of the same maximum current value.
NH4-2-32
POWER
SUPPLY
8 7 6
24 Vac
FBus BMS2
Figure 2.4. ecoSMART e-manager power supply scheme.
31
Installer manual ecoSMART e-manager
CHiNT
J16 J17 J18
J10 FBUS1 J11 BMS2 J14 pLAN
J27
J15
pCOOEM+
J25
5
J1 J2 J3 J4 J5
pLAN
NC
COM
NO
COIL
J19 J20 J21 J22 J23 J24
J28
J29
J26
J6 J7
DI1 DI2 DI3 DI4 DI5 DI6