General Instructions - ECOFOREST ecoSMART e-manager Installerhandbuch

2.3.

General instructions

The location of the main components of the ecoSMART e-manager are shown below.
4
5
The e-manager uses the information collected by a serie of installation elements to carry out the control and regulation actions
that allow maximizing its efficiency. For this reason, it is essential to make a correct connection of your e-manager with the
different external devices that make up your installation. The internal components of the electrical box are connected from factory.
3
2
CHiNT
NH4-2-32
POWER
SUPPLY
1
J10 FBUS1 J11 BMS2 J14 pLAN
J15
pCOOEM+
8 7 6 5
J1 J2 J3
9
24 Vac
FBus BMS2 pLAN
6
Nº
1 Power supply terminals.
2 Controller switch.
3 0.5A fuse.
4 230/24 Vac transformer.
5 24Vac distribution.
6 2A fuse.
7 pCOOEM+ controller.
8 Digital inputs connections.
9 Communication ports.
10 Block of relay outputs.
Figure 2.3. Location of the components in the box.
Installer manual ecoSMART e-manager
NC
COM
10
NO
COIL
7
J16 J17 J18 J19 J20 J21 J22 J23 J24
J27 J28
J25 J26
J4 J5 J6
DI1 DI2 DI3 DI4 DI5 DI6
8
Descripción
30
J29
J7