GUTMANN VIENTO Montageanleitung Seite 24

EN
Assembly preparation / Worktop / Kitchen furniture :
Installation, important notes !
• Avoid excessive heat generation from below, e.g. from a baking oven without cross-
flow fan.
• The induction hob must not be used when pyrolysis operation takes place on built-in
cookers.
• When installing above a drawer, care must be taken to ensure that no sharp objects
are stored in the drawer. These could tilt on the underside of the hob and block the
drawer.
Ensure that the cooktop inductors are adequately ventilated.
• The cooktop must not be installed above refrigerators, dishwashers, washing machi-
nes or dryers.
• It must be ensured that no flammable, easily ignitable or heat deformable objects are
placed directly next to or below the hob due to the risk of fire.
Hob gasket
Wood worktops must be sealed on the cut surfaces. Before installation, the enclosed
cooktop gasket must be inserted without gaps.
It must be prevented that liquids can penetrate between the edge of the hob and the
•
worktop or between the worktop and the wall into any electrical appliances installed
underneath.
• If the hob is installed in an uneven worktop, e.g. with a ceramic or similar covering
(tiles, etc.), the sealing must be carried out with level compensation of the cooking
surface against the worktop using plastic sealing materials (e.g. Novasil® or Ottose-
al® ).
Note: If sealing adhesive is used for sealing and fixing, a later, non-destructive remo-
val of the hob cannot be guaranteed.
Worktop cut-out
The cut-out in the worktop should be made as accurately as possible with a good, strai-
ght saw blade or a router. The cut surfaces should then be sealed to prevent moisture
from penetrating. The cut-out for the hob is made according to the illustrations. The
glass-ceramic hob surface must be flat and flush. Tensioning can cause the glass plate
to break. Check the seal of the cooking surface for a perfect fit and complete support.
PU sealing tape 3x10mm at the mount bearing surfaces all around. Flush mounting al-
so possible in the countersink. Consider the height of the glass plate. Level adjustment
if required.
24