Maintenance And Cleaning; Disposal And Recycling - Scheppach 7906100735 Original Bedienungsanleitung

Using the tyre inflator gauge (2)
1. Place the valve connector (5) on to the valve
2. Press the trigger (6) to start the delivery of air.
3. Release the trigger (6) to stop the delivery of air.
Read off the filling pressure on the gauge 1 .
4. If the object is overfilled with air (air pressure too
high): Press the deflator valve (3) to release some
air.
5. Press the lever of the valve connector (5) down-
wards and pull the valve connector (5) off the
valve.
6. After you finish work, disconnect the device from
the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.
Using accessories:
• Press the lever of the valve connector (5) and insert
the desired accessory (10) to (13) or the cap (9) into
the valve connector (5)
Using the blow gun (7)
1. Screw an extension nozzle (8) on to the blow gun
(7) .
2. Press the trigger (6) to start the delivery of air.
3. Release the trigger (6) to stop the delivery of air.
4. After you finish work, disconnect the device from
the compressor.
NOTE: First disconnect the hose from the com-
pressor and only then disconnect the compressed
air supply hose from the device. This will ensure
that the compressed air supply hose does not
wave around in an uncontrolled manner.

8. Maintenance and cleaning

DANGER OF INJURY! Always disconnect the device
from the compressed air source before you clean or
maintain it.
The device requires no maintenance.
• Do not use sharp objects for cleaning the device.
Do not allow any liquids to enter the device. Other-
wise the device could be damaged.
• Clean the device frequently; for best results, do this
immediately after you have finished using it.
• Clean the housing with a dry cloth.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

9. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
GB | 13